Правила форума


1. Только чтение и размещение отчетов. Задавать вопросы в Конференции.
2. Как добавлять изображения и фотографии указано вот тут.
3. Указывайте в отчете модель, год, двигатель, тип коробки!!!
Нарушения будут наказываться.



Начать новую тему Ответить на тему  [ Сообщений: 5 ] 
Делаем холодильник для пива в бардачке (можно для кокаколы) в Audi A4 B5 (A4 B5) 
Автор Сообщение
Доброволец

Зарегистрирован: 28 окт 2009, 18:08
Сообщения: 2239
Модель AUDI: А4 АЕВ
Город: Минск
Что понадобится
Part number: 8E1816311 AIR HOSE
Price: $8.00 Quantity: 1
Part number: 8E08207014PK AIR OUTLET
Price: $23.51 Quantity: 1
(источник в США, цены оттуда же - но у кого руки из правильного места - разберутся и с ценами и с запчастями. По этой же причине не буду текст переводить :smu:sche_nie: все понятно по картинкам)


Tools needed:

8mm socket with a minimum 9" extension arm
Hammer
Flat Head Screwdriver
Picture of parts:
Вложение:
1.JPG

Begin with taking the glove box out. There are 9 screws.

7 are located inside the glove box and are easily located. The last two are located under the glove box on the extreme left and right sides of the passenger footwell area.

It's highly recommended that you use an extension arm for your socket driver when trying to reach the two screws in the back of the glove box. They are nearly impossible to get out without an extension.

Removing the top screws.
Вложение:
2.JPG

Next you should disconnect the power harness to the glove box light.

Connected:
Вложение:
3.JPG

Disconnected :
Вложение:
4.JPG

You should see the plug for the A/C duct near the back of the center console. Just give it a tug and pull the rubber plug out.

Rubber Plug:
Вложение:
5.JPG

Removed Plug:
Вложение:
6.JPG

Now install the glove box air duct by lining up the keyed end of the pipe with the hole. Once it's lined up you will need to give it a counter clockwise turn, about a 1/4 turn. The duct should feel nice and snug with no movement at all when touched.

Duct in the keyed position (before the 1/4 turn)
Вложение:
7.JPG

After 1/4 turn:
Вложение:
8.JPG

Next you will need to tear the insulation along the perforations. It's obvious the area that needs to be removed. Just pull easily while holding back the rest of the insulation with your other hand so that you don't rip the entire insulation from it's connection to the back of the glove box.
Вложение:
9.JPG

Without insulation:
Вложение:
10.JPG

The next step is to remove the temporary hole cover in the back of the glove box. (See picture above)

Punch out the hole using the flat head screw driver and the hammer. Just line the flat head screw driver up over the small pieces of plastic that is holding the hole cover onto the rest of the assembly. There are four locations. You will want to prevent damaging the glove box by not hitting the screw driver too hard. A small tap should do the trick.

Temporary Hole Cover seen below (Stock configuration):
Вложение:
11.JPG

Now all that's left is to re-install the glove box. If done correctly, the air duct you installed should line up perfectly with the glove box hole. It's best if you support the bottom of the glove box with something so you can use both hands to turn the socket screws
Вложение:
12.JPG

Picture of the glove box reinstalled:
Вложение:
13.JPG

Next screw the valve cover onto the pipe and you're done.
Вложение:
14.JPG

Valve Open to let cool air in:
Вложение:
15.JPG

Here is all the left over parts you should have (Rubber plug not shown. That is a leftover part too):
Вложение:
16.JPG

CAUTION: It was brought up that the proper glove box should be installed along with this. You can buy this expensive part (~$125) or use a small tray when keeping drinks in the glove box to prevent condensation from soaking the soft lining inside the box. Mold and other funky things could start growing if you don't do this.

Вот и все, короче...
Источник


У вас нет необходимых прав для просмотра вложений в этом сообщении.


Профиль

Зарегистрирован: 08 фев 2010, 23:31
Сообщения: 1
Модель AUDI: A4 B5 Avant, 00, AKN
Город: Киров
А на A4 B5 можно установить?

Вродеб раздел по B5, а отчет по B6


Профиль
Доброволец

Зарегистрирован: 28 окт 2009, 18:08
Сообщения: 2239
Модель AUDI: А4 АЕВ
Город: Минск
у меня на Б5 нет заглушки в воздуховоде, к сожалению. :-)
Снять надо бардачек - сложного в этом ничего нет - и посмотреть.


Профиль

Зарегистрирован: 03 май 2011, 17:32
Сообщения: 1
Модель AUDI: A4 1.8 1997
Город: Бобруйск
Страна: беларусь
Я СЕБЕ СДЕЛАЛ! :co_ol:


Профиль
AUDI-FAQ.COM TEAM
Аватара пользователя

Зарегистрирован: 21 фев 2010, 11:12
Сообщения: 662
Модель AUDI: A4/B5/ADP/CTD/97г.
Город: Оренбург
mixa88 писал(а):
Я СЕБЕ СДЕЛАЛ!

Ну так покажи фотки, как смотрится на Б5)


Профиль ICQ
Показать сообщения за:  Поле сортировки  
Начать новую тему Ответить на тему  [ Сообщений: 5 ] 


Кто сейчас на конференции

Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 1


Вы не можете начинать темы
Вы не можете отвечать на сообщения
Вы не можете редактировать свои сообщения
Вы не можете удалять свои сообщения
Вы не можете добавлять вложения

Перейти:  
cron




Rambler's Top100 мЮЬЮ ЯРПЮМХЖЮ Б Facebook

Энциклопедия по ремонту AUDI-FAQ.COM © 2009-2013. Все права защищены.